New power supply for my rebuilt Up Plus 3D printer.

Advertisements

With the addition of the Raspberry Pi to my rebuilt Up Plus 3D printer I now have three power supplies connected to the machine. The heated bed is using the original 19V power supply that came with the Up, the RAMPS 1.4 and hot-end are using the 12V supply from my old Prusa and the Raspberry Pi is using an old 5V phone charger. This is a lot to connect to start the printer.

I want to simplify things by just using the 19V supply and fit the machine with two step down voltage regulators. I would need one regulator to step the 19V down to 12V and a second to step down again from 12V to 5V. The 5V is easy as the Raspberry Pi Zero W only draws 250mW max so any USB power supply will work. I settled with a dual USB 15W switch mode supply that can handle 6V – 40V input. The larger supply and dual ouput would be handy if I add a WiFi camera later.

The 19V to 12V supply needs to supply the RAMPS 1.4, Arduino, stepper motors and the hotend. I calculated the peak power draw to be 30W (2.5A). I chose a 50W Power Supply Module that included an LCD display that shows the current draw and voltage. The Ebay listing shows that the unit can supply 35W constant without cooling and 50W with the supplied heatsink. I also added a cooling fan.

The supposed 50W power supply the couldn’t handle 30W

The first test run had the 12V supply showing peak current draw of under 2.5A so less than 30W but the heatsink was getting too hot to touch even with a fan on it. 10 minutes into the print the printer stopped with the 19V supply shutting down due to short circuit protection. The second MOSFET on the 12V supply had failed short circuit. I contacted the Ebay seller wh didn’t respond to any e-mails. Swindled.

With a doubtful attitude to Ebay sellers I decided to replace the 50W supply with a 200W supply. This new supply doesn’t have a fancy LCD but it shouldn’t burn up during basic use. I kept the cooling fan just to make sure and the power supply is cool during use.

The new 200W 12V supply.

Now with only one power cable this printer is almost looking finished.

Leave a Reply